Overview
Dual AC charging station with tethered cable and Type 2 socket
e:car WALL double SMART charges two vehicles at the same time at up to 2× 22 kW, via a tethered cable and a Type 2 socket. Output adapts to the building's consumption, and the stainless steel body with tempered glass and IP54 rating allows indoor or outdoor installation. Designed and manufactured in the Czech Republic.
Key features
Two outputs
A tethered Type 2 cable, 5 m as standard (8, 10 or 12 m optional), and a Type 2 socket built into the housing. The cable connector withstands a load of 2 t.
Power management
Normal, Eco and Boost modes. A built-in meter on the main supply measures household consumption and export to the grid. The station does not communicate with the inverter, so it works with photovoltaic systems of any make, including after a replacement.
Residual current protection
EV residual current device for each output (AC 30 mA + DC 6 mA); no Type B RCD is required.
Thermal protection
Sensors in the power electronics, in the connector and at both ends of the cable. If the cable exceeds 100 °C, the station stops charging.
Connectivity and metering
Wi-Fi and LAN, management in the IONT.info app, RFID access and over-the-air (OTA) firmware updates. The station measures energy in kWh, voltage, current and grid frequency. Via Modbus TCP the station can be controlled from Home Assistant, Loxone or a building energy management system.
Construction and warranty
Stainless steel body, tempered glass and a lockable housing with a shaped lock, IP54 rating, operation from −30 to +50 °C. Warranty: 2 years on the unit, 3 years on the power electronics.
Technical specifications
| Power supply | 3× 400 V AC, 50 Hz or 1× 230 V AC, 50 Hz |
|---|---|
| Charging power | up to 2× 22 kW (three-phase) |
| Outputs | tethered Type 2 cable + Type 2 socket |
| Cable length | 5 m (8, 10 or 12 m optional) |
| Protection | EV RCD for each output, AC 30 mA + DC 6 mA |
| Temperature sensors | power electronics, connector and both cable ends |
| Metering | energy consumption in kWh, grid frequency, voltage and current |
| Power management | Normal, Eco and Boost modes; Modbus TCP |
| Communication | Wi-Fi, LAN, Modbus TCP |
| Authorisation | autonomous mode, RFID, IONT.info app |
| Updates | over-the-air firmware (OTA) |
| Status indication | RGB indicator with automatic dimming and selectable colours |
| Ingress protection | IP54, indoor and outdoor |
| Operating temperature | −30 to +50 °C |
| Construction | stainless steel body, tempered glass, shaped lock |
| Front panel | Burberry stripes, Antracit stripes, White |
| Mounting | wall or optional stand |
| Wire connection | push-in terminals |
| Standards | IEC 61851, IEC 62196 |
| Made in | Czech Republic |
Charging modes
| Normal | Output adapts to the building's current consumption. |
|---|---|
| Eco | Charges primarily from PV surplus that would otherwise be exported to the grid. |
| Boost | Charges at maximum output regardless of the building's current consumption. |
IONT.info app
Overview
Charging statistics and real-time monitoring.
Access
Remote authorisation and RFID card management.
Users
Management of station users.
Scheduling
Timer to start charging.
Choosing a version
The comparison page explains the difference between cable and socket versions and recommends the right output. Installation and commissioning are carried out by certified IONT partners.